User manual
Radiocrafts
Embedded Wireless Solutions
RC-IESM-Series
2010 Radiocrafts AS RC-IESM User Manual (rev. 1.20) Page 8 of 14
The MBUS-DEMO can directly communicate with MBUS-IESM boards and handles ‘0x00’-
command inside the tool. Especially useful is the packet sniffer tab and after enabling RSSI in
the setup tab: Incoming wireless M-Bus packages can then directly be monitored with its
signal strengths. See MBUS-DEMO User Manual for details.
Figure 4: MBUS-CCT Window
Handshake enable:
- Enable CTS and/or RTS in configuration memory as described in module datasheet
- Ensure that R49 and R50 (0 ohm 0603 size) are mounted on IESM board. One or
both are by intention not soldered in production
Terminal Window