Specifications

WA_DEV_FEX20_PTS_003 Rev 002 May 26, 2010 15
Battery Accessory Product Technical
Specification
Battery Accessory Charging
4.2. USB Charging
Pin 1 of the Micro-fit connector is connected to Vbus, which is used to charge the battery accessory
via USB. The USB connector is located on the front interface of the Fastrack Xtend.
Figure 7. USB Connection from the Fastrack Xtend
For USB charging, a USB cable is connected to the Fastrack Xtend while it is connected to the battery
accessory via the battery cable as shown in the figure below.
Figure 8. USB Charging
For more information about these connections, refer to document [2] AirLink FXT Series User Guide.
4.3. Charging Time
Refer to the following table for the charging times for both DC-IN and USB charging.
Table 2: Battery Accessory Charging Time
Battery Type
Battery Capacity
Power Source
Charging Time
NiMH
500mAH
DC-IN
~14Hrs
USB
~16Hrs
USB Interface from the Fastrack Xtend
Battery Cable
Fastrack Xtend
Battery Accessory
USB Cable