Installation guide

AirCard 800 Series Installation Guide
radiation, the maximum antenna gain must not exceed
8 dBi in the Cellular band and 4 dBi in the PCS band.
3. The AirCard 850 / 860 / 875 wireless network cards and
their antennas must not be colocated with any other trans-
mitter or antenna within a host device.
4. A label must be affixed to the outside of the end product
into which the AirCard wireless network card is incorpo-
rated, with a statement similar to the following:
• For an end product with an embedded AirCard 850
wireless network card:
This device contains FCC ID: N7NAC850.
This equipment contains equipment certified under IC:
2417C-AC850.
• For an end product with an embedded AirCard 860
wireless network card:
This device contains FCC ID: N7NAC860.
This equipment contains equipment certified under IC:
2417C-AC860.
• For an end product with an embedded AirCard 875
wireless network card:
This device contains FCC ID: N7NAC875.
This equipment contains equipment certified under IC:
2417C-AC875.
5. A user manual with the end product must clearly indicate
the operating requirements and conditions that must be
observed to ensure compliance with current FCC / IC RF
exposure guidelines.
The end product with an embedded AirCard 850 / 860 / 875
wireless network card must pass the unintentional emission
testing and properly authorized per FCC Part 15 requirements.
Note: If these wireless network cards are intended for use in a
portable device, you are responsible for separate approval to satisfy
the SAR requirements of FCC Part 2.1093 and IC RSS-102.
42 2130623