User guide

AirLink GX400 HSPA+ User Guide
32 2140712
Light Patterns
The LEDs on the front of the device respond with different light patterns to
indicate device states.
• Normal - Each LED is lit as applicable.
•Start up and Device Reboot - All LEDS simultaneously cycle red, yellow,
and green at the start. Various light patterns continue until the Power LED
turns yellow and then green, and the Network LED flashes yellow, changes to
a solid yellow, and finally turns green, to indicate an active device.
• Radio Passthrough (H/W) - Network LED is a solid red.
• Factory Reset - All LEDs flash yellow after the Reset button is pressed for
7-8 seconds and released. Returns the device’s software settings to the
factory default state.
• Data Retry, Failed Auth, and Retrying - The Network LED blinks red every 3
seconds.
Reset Button
The Reset button, located on the right front side of the AirLink GX400, has two
primary functions:
1. Powers up or reboots the device: Quickly press in and release.
2. Return the device’s ALEOS configuration settings to their factory defaults:
Press in and hold for 7-8 seconds until all LEDs are flashing yellow.