User guide

Installing and Activating AirLink GX400
Rev 2.0 Feb.12 25
Activating the AirLink GX400
To activate your GX400:
1. Install the AirLink GX400 antennas - See Connecting the Antennas on
page 26.
2. Remove the GX400’s top cover by removing the four retaining screws with a
5/64” or 2 mm Allen wrench. Insert a SIM card into the SIM tray. Replace the
screws and cover.
3. Plug the power cable into the power connector on the back panel of the
AirLink GX400 - See Connecting to Power on page 27.
4. Connect your computer to the AirLink GX400 with an Ethernet, serial, or USB
cable - See Connecting to a Computer or Other Device on page 29.
5. Observe the LEDs - See LED Operation on page 31.
Wait 60-90 seconds for the AirLink GX400 to initialize and go on the air.
Updating AirLink GX400 Firmware
Install the latest firmware version (.exe file) from ACEmanager using the
Firmware link.
Confirming the IP Address
Check the IP Address in your Local Area Connection window. The IP Address in
the window in Figure 3-2 is for a USB/net connection.
Figure 3-2: Confirm IP Address