User guide

AirLink GX440 for Verizon LTE User Guide
26 2140712
Configuring Through ACEmanager
ACEmanager is a free utility. Follow the steps below to connect to ACEmanager
and begin configuring the device.
• Ensure that the AirLink GX440 is properly connected to allow access to the
ACEmanager user interface.
• Go to http://192.168.13.31:9191 the first time you connect to ACEmanager.
Exchanging SIMs
If your SIM has custom APNs assigned, the Verizon Wireless network will
automatically update the APNs stored on the GX440 over the air during first time
startup.
Follow these steps to allow the APNs to update over the air:
1. Unplug the GX440 from the power source.
2. Insert the SIM card into the SIM card slot using the SIM installation procedure
covered in Activating the AirLink GX440.
3. Replug the GX440 back into the power source.
The GX440 will search for and find the Verizon network and allow the Verizon
network to update the APNs stored on the GX440. Updating the APNs takes
approximately 2 - 15 minutes. If you know the IP address of your Verizon network
connection and have access to ACEmanager, the APNs have successfully
updated when ACEmanager shows the correct IP address in its IP address
section.
Power cycle the GX440 when the APNs have been successfully programmed.
Connecting Antennas
Warning: This device is not intended for use within close proximity of the human body.
Antenna installation should allow for a separation of at least 20 cm from the operator.
The GX440 requires the use of two antennas in a MIMO configuration. The
antennas selected should not exceed a maximum gain of 7.3 dBi in Cellular Band,
3 dBi in PCS band, or 9 dBi in Band 13 under any standard installation
configuration. In more complex installations (such as those requiring long lengths
of cable and/or multiple connections), it is imperative that the installer follow
maximum dBi gain guidelines in accordance with the radio communications
regulations of the Federal Communications Commission (FCC) or Industry
Canada.
The AirLink GX440 will require antennas that support the Verizon LTE network.
Connect the primary antenna or primary RF cable directly to the antenna
connector on the back of the AirLink GX440.