User guide

AirLink Raven XE HSPA User Guide
46 20080616
Figure 6-4: HyperTerminal : connected
a. If you are prompted for a password, enter the default password 12345.
Tip: You will not be prompted for a password if you connect using a COM port.
b. Typ e AT and press Enter. You should get a reply of “OK” or “0”.
c. To see what you are typing as you type it, you will need to turn on the
echo and verbose mode. Type AT E 1V 1 and press Enter.
d. If you get a reply of “OK”, then you entered the command successfully. If
you get a reply of “0” or “ERROR”, try entering the command again.