User manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the SL-14RC Master Controller
10
The wiring from a K-Net port to a single RC-3TB is shown in Figure 6.
Figure 6: K-Net to RC-3TB Connection
6.3.1 Terminating RC-3TB Remote Control Panels
If only one RC-3TB is connected, it must be terminated and the termination
on the SL-14RC is turned off (see
Section 6.3.1). When viewed from above
and the rotary switch is to the left of the termination switch, slide the
termination switch to the left as shown in
Figure 6.
Only the last RC-3TB in the chain should be terminated.
6.3.2 Daisy-chaining Multiple RC-3TB Remote Control Panels
The wiring of two RC-3TB panels to the K-NET port on the SL-14RC is
shown in
Figure 6. Connection of more than two RC-3TB panels follows the
same principle.
Figure 7: Daisy-chaining Multiple RC-3TB Panels
Note the position of the termination switch on the first RC-3TB (open, to the
right), and that of the second RC-3TB (closed, to the left).