User manual

Connecting the SL-14RC Master Controller
9
 Connect RS-232 port 1 to the projector
 Connect RS-232 port 3 to the plasma display
5. Connect the Ethernet port to a network.
6. Connect the K-Net port to the input of the first RC-3TB Remote Control
Panel (see
Section 6.3
7. Connect the output of the first RC-3TB Remote Control Panel to the
input of the second RC-3TB Remote Control Panel (see
).
Section 6.3.1
6.1 Connecting the RS-232 Interface
).
To connect an AV device to the SL-14RC using the RS-232 port, connect the
RS-232 9-pin D-sub port on your AV device to the RS-232 terminal block on
the rear panel of the SL-14RC as shown in
Figure 5.
Figure 5: RS-232 Connection
6.2 Connecting the Ethernet Port
The Ethernet connection of the SL-14RC lets you perform all control
functions of the SL-14RC over the Internet using a PC running the Kramer
Site-CTRL control program.
To connect the SL-14RC to a network:
1. Connect the Ethernet port of the SL-14RC to the Ethernet port on a network
hub or network router, via a straight cable with RJ-45 connectors.
2. At the other end, connect the Internet to a PC running Site-CTRL.
After connecting the Ethernet port, you have to install and configure it. For
detailed instructions on how to install and configure your Ethernet port, see
the RC-SV Configuration Guide available from our Web site
1
6.3 Connecting RC-3TB Remote Control Panels (Optional)
.
One or more RC-3TB panels may be connected to the K-Net port on the
SL-14RC in a daisy-chain configuration.
1 At http://www.kramerelectronics.com