User`s manual

Sierra Video
56
Updating the Scalers
Some firmware updates may include additional revisions for the video board scalers. The
requirement for updating the scalers can be determined by going to the - menu. If any
scalers need updating, then there will be a tag "needs updating" next to the scalers listed.
Where scaler updates are required, proceed with steps 1 to 3 above and continue as
follows (note that this process takes approximately 25 minutes):
Open a DOS command window.
At the command prompt type; ‘telnet 192.168.0.120’, or whatever the current IP address
is set to.
Log in with the user name ‘root’, using the password ‘smv’.
Type; ‘./update-scalers’
The status of the update will be indicated in the command window. Ensure that when the
process is complete, all scalers have been updated (there are four scalers).