User`s manual

Sierra Video

Configuration Mode

To enter the configuration mode from normal mode (with the red Lock LED off) hold the

Lock button down for about 3 seconds. The configuration or ‘menu’ mode will be entered,

an on-screen menu will appear and the red Lock LED will illuminate. If the Lock button is

depressed again, any changed settings will be saved and the unit will return to normal.

The currently loaded firmware version will be indicated at the top of the on-screen menu.

The main ‘menu’ mode controls are as follows:

 Function keys (up/down arrows) scroll the menu cursor up and down to select the

desired function.

 Select Parameter keys (left/right arrows) select settings to apply to the chosen

parameter.

 Lock button exits 'menu' mode and saves settings.

SYSTEM CONFIGURATION PARAMETERS

Network Settings Set manually (using settings below) / Use DHCP

IP Address Enter frame IP address byte at a time in the sub-menu

Netmask Enter Subnet Mask byte at a time in the sub-menu

Gateway If required, enter the Gateway address byte at a time in the sub-

DNS Server 1 If required, enter the DNS server address byte at a time in the sub-

DNS Server 2 If required, enter the DNS server address byte at a time in the sub-

Network Settings

These settings only need to be manually entered if DHCP is not to be used. This would

be required for a network that uses fixed IP addresses and does not rely on a DHCP

server to allocate them automatically.

The IP address must be unique on the network. Please see your system administrator if

these details are required.

Keyboard Operation

Any HID compliant USB keyboard can be used for the entry and editing of UMDs. The

keyboard is connected to the USB port on the front panel of the SM-xx, or alternatively,

the SV-Remote remote control unit. Note that a keyboard connected to a remote control

unit that has been assigned to more than one multi-viewer at a time (‘collective mode’)

can serve no function (see the Remote Panel section).

The Tab key activates the cursor on the topmost UMD. Successive Tab key operation

moves the cursor on to the next UMD in sequence. The Esc key deactivates the cursor.

All multi-viewer factory default settings (including the IP address) are restored with the

Ctrl-Alt-Del command.