User`s manual

SIERRA VIDEO
28
Syntax Example Description
R R Router Reset
I I Capabilities Inquiry
Q Q Model Name and Software Version
Inquiry
L L Matrix Size and Level Names Inquiry
O O5 Output Status inquiry
N N5 Input Status inquiry
S S Status inquiry
C C Clear matrix
K K9999 Set Password to Change Protected
Settings
M M139 Set Remote Address
U {0 1} U0 Update request on/off
V out,in,in… V3,1,2,2 Connect levels
W lvl,in,in… W1,4,19 Connect outputs
X out,in,lvl X12,9,2 Connect crosspoint
Y out,in Y1,7 Connect AFV
Z in in… Z13,12,8 Connect AFV
D numsyncs D300 Delay vertical sync intervals
T {A-Z} TB Trigger a Salvo Connect sequence
P {A-Z} PBY1,7~ Preset a Salvo connect sequence
B B21 Output Lock inquiry or change
F F5 Field Delay for crosspoint output
HOST HOST0 Select Host or Terminal Protocol
G G1,10~ The command “G” is used to query
or modify a router configuration
parameter or parameters.
“R”: Router Reset
Use this command to force the routing switcher to reset, by sending it the command “RESET”. If
an administrator password has been set (using the “G ADMIN_PASSWORD” command
described later in this document), then the password must be sent in a “K” message prior to
sending this command, else this command will generate an error. For example, the command:
**RESET!!
Would initiate a reset (if the password has been entered, if required), and when the router
finished the reset operation, something like this would be received, just as if the router had
powered up:
** RESET Tahoe Vx.xx I 2000~ !!<CR>