User`s manual

SIERRA VIDEO

Adjust Input Termination – Input termination for each H and V input can be adjusted to 75 or

510ohm. Factory default is 75ohm

Select System Parameters – Selecting system parameters allows access to disable the front

control panel and view the system information- configuration and software version.

Adjust Audio Gains – This menu path allows the input gain to be adjusted. The input gain may

be changed from –10db to +20db in .5db to 1db increments. The output gain can be changed

from output mute, -61db to +15db in .5db to 1db increments.

Select Salvo Register – Allows selection and execution of Salvos stored in the router. A Salvo is

a group of Sources and Destinations that are stored in the routing switcher and switched by a

single “Salvo Take” command. TyLinx Pro Routing Software allows up to 256 Salvos to be named

and stored in the routing switcher. The salvo name will be displayed in the Salvo register. Salvos

are made and stored in the router using the TyLinx Pro Software program. See the TyLinx Pro

Software manual for details on creating and storing salvos.

Adjust A/V muting – A/V muting selects a delay time before audio and video appears after

“Take” is pressed. Sync will be switched with only the audio and video being delayed. The range

of adjustment is from 0 to 10 seconds in .5 second increments.

Select Room Grouping – A room group is a “user defined” group of inputs, outputs, and levels.

Room Groupings are configured and stored using the TyLinx Pro Software program (see the

TyLinx Pro Software manual for details on creating and storing Room Groups), or Room Groups

can be configured using the serial port (see the Communications Protocol chapter of this

manual).

Switching the Router

Switching AFV (all levels);

 Press [V/A] until the screen displays “Preset AFV” (all levels).

 Press [Select] until “Out” is flashing.

 Choose the output using the rotary knob.

 Press [Select] to cause “In” to flash.

 Choose the input using the rotary knob.

 Press [Take] to activate the switch.

Note:

The router can also be switched by selecting the source first by reversing the order of selecting.