User`s manual

INSTALLATION
15
AC Power Connections
SV routing switchers offer redundant power supplies but must be specified prior to order. The
power supplies are universal AC inputs. Voltage selection is not necessary because the power
supply senses the correct AC input automatically.
The Series 32 models use a power switch located on the rear of the frame. Turn on power to the
frame ONLY AFTER all video and control connections have been completed as described.
Warning:
Power to Audio frame must be on before applying power to the Video
frame.
Control Processor Dip Switch Settings
Your switcher has been configured at the factory for the settings you are most likely to need.
However, if you want to configure the switcher differently, you can do so by setting the switches
located on the processor board (behind the front panel). Dip Switches and their action are given
in the table that follows. Dip Switches are shown in their factory default settings.
Port 2 Speed (S 1)
Host (Port 1) Protocol Send X (or X, Y, and V) Command (S
2)
*9,600 baud *1 off Initially Disabled 1 off
19.2 K baud 1 on * Initially Enabled *1 on
Port 2 Initial Protocol (S 1) Control Panel RS-485 Port Speed (S 2)
* Terminal 2 off 9.6 K baud 2 off
Host *2 on * 31.25 K baud *2 on
Port 1 Speed (S 1) Software Download and Update (S 2)
1.2 K baud
3 off
4 off
* Normal Operation *3 off
Download New Software 3 on
* 9600 baud
*3 on
*4 off
Port 1 Initial Protocol (S 2)
Terminal 5 off
38.4 K baud
3 off
4 on
* Host *5 on
Serial Port Protocol Router Status Commands (S 2)
115.2 K baud
3 on
4 on
* X Command Only *6 off
X, Y, and V Commands 6 on
Port 1 Word Length (S 1) Force Crosspoint Initialization (S 2)
7 data bits 5 off * Restore Previous Crosspoints *7 off
* 8 data bits *5 on
Initialize Crosspoints 1-1, 2-2,
etc.
7 on
Port 1 Parity Type (S 1) Initialize Non-Volatile Memory (S 2 )
* Even *6 off * Normal Operation *8 off
Odd 6 on Clear All Settings 8 on
Port 1 Parity (S 1)
* = Factory Settings S 2 Switch 4 is Unused
* Disabled *7 off
Enabled 7 on
Port 1 Send Xon/Xoff (S 1)
Disabled 8 off
* Enabled *8 on
Note:
Changing any Dip Switch causes an automatic reset after a few seconds.