User`s manual

SIERRA VIDEO

Connecting Peripherals

Control panels, sync inputs, and power are all connected to the rear of the frame. The peripherals

area may vary depending on the model size and type.

SV Pro series 32 routing switchers offer redundant power supplies.

Note:

Rear Panels vary according to model. See back panel for precise detail.

J1 Connector

The connector labeled J1 on the back panel is used to connect other routing devices to the

router. Contact the factory for correct configuration before connecting other devices.

Sync Input

There are two BNC connectors labeled “VID. REF. IN”. This is a “looping” input for sync

referencing. Connect either composite sync or video with sync to either BNC. If desired, use the

second BNC to loop the signal to another device. If the loop is not used, terminate the second

BNC with 75 ohms. If no sync is available, the routing switcher will switch at a random point

rather than during the vertical interval of the reference signal.

ideo Sync

Referencing

Inputs

RS-232 and RS-

422 control

connector

Control Panel

Connectors

Fuses

Power Switch

AC Power

Connection

J-1 Multi-Frame

ector

These Connectors

Not Used