User`s manual

SIERRA VIDEO
10
Connecting To Video Devices
Video sources and output devices (such as monitors, or recorders) may be connected to the
routing switchers through the BNC type connectors located on the back of the unit. Keep in mind
that the output signal format will be that of the input signal format.
All signal connections that use more than one cable interconnecting between devices should be
of equal timing length (example: cables between a camera and the switcher should have the
same time delay).
The rear panel of the frame is laid out in the most logical fashion possible. The individual
channels are color-coded. The white and yellow conventions, used for the H and V sync
channels, are arbitrary and these two channels are interchangeable. Each channel can have only
“H” or “V” signals – not both. All inputs are factory set for 75 ohm termination.
The sync (“H” “V”) input terminations can be changed to 510 via software using “G” commands,
front panel Menu, or the TyLinx Pro software (see the TyLinx Pro manual for details).
Module Layout
Note
The model shown is a fully populated video
(V3 + 2 sync) matrix. In some cases frames
may be configured with fewer or all video
channels i.e. 3232V2 or 3232V3.
The system you receive is customized for
the size & type requested at time of
purchase.
Processor
Module
Video
Modules
Sync
Modules