Instruction manual

Instruction Manual Smart-Trak
®
50 Series
IM-50 Rev. A.2 19
3. Select the ComPort pull down menu shown
As shown above, use the pull-down menu to choose the port number that corresponds to the
serial port channel your 50 Series is connected to. Depending on whether the unit is RS-232 or
RS-485, you’ll need to select the proper “ASCII Commands” setting to match as shown above
right.
If your unit is RS-485, you’ll want to match the Device Address, Baud Rate and Parity to that of
your instrument (default settings are shown below). Once you have established communication,
you can change the Device Address, Baud Rate, and Parity to set up the instrument for use on
your RS-485 Bus system.