User`s manual

SIERRA VIDEO

Troubleshooting

Introduction

NOTES:

If the output signal is disturbed or interrupted by electromagnetic interference, the signal

should return and stabilize when the interference ends. If not, turn the power switch off

and on again to reset the switcher.

If the following recommended actions still do not result in satisfactory operation, please

consult your Sierra Video Dealer.

Power and Indicators

Problem Remedy

No power  Confirm that the rocker switch is in the “ON” position, and that the

power lamp is illuminated.

 Confirm that power connections are secured at the switcher and at

the receptacle. Make sure the receptacle is active, with the proper

mains voltage.

 If there is still no power, check the fuse. Remove power cord from

the AC outlet and from the switcher and then remove the fuse

holder located above the power connector. Confirm that the fuse is

good by looking at the fuse wire connected to the ends of the fuse.

If the wire is separated, replace the fuse.

Chapter