User`s manual

WARNINGS & SAFETY REGULATIONS
3
Cautions (continued)
? Use only the recommended interconnect cables to connect the switcher to other
frames.
? Follow static precautions at all times when handling the equipment.
? Power this product only as described in the installation section of this manual.
? Leave the side, top, and bottom of the frame clear for air convection cooling and to
allow room for cabling. Slot and openings in the frame are provided for ventilation
and should not be blocked.
? Only an authorized Sierra Video Systems (SVS) technician should service the
switchers. Any user who makes changes or modifications to the unit without the
expressed approval of Sierra Video Systems will void the warranty.
Power Supply Cords
North American Power Supply Cords
This equipment is supplied with North American power cords with molded grounded plug (NEMA-
15P) at one end and molded grounding connector (IEC 320-C13) at the other end. Conductors
are CEE color coded, light blue (neutral), brown (line), and green/yellow (ground). Operation of
the equipment at voltages exceeding 130VAC will require power supply cords that comply with
NEMA configurations.
International Power Supply Cords
If shipped outside North America, this equipment is supplied with molded ground connector (IEC
320-C13) at one end and stripped connectors (50/5mm) at the other end. Connections are CEE
color coded, light blue (neutral), brown (line), and green/yellow (ground). Other IEC 320-C13 type
power cords can be used if they comply with safety regulations of the country in which they are
installed.
EMC Regulatory Notices
Federal Communications Commission (FCC) Part 15 Information: This device complies with Part
15 of the FCC standard rules. Operation is subject to the following conditions:
This device may not cause harmful interference
This device must accept any interference received including interference that may cause
undesirable operations.
Delivery Damage Inspection
Carefully inspect the frame and exterior components to be sure that there has been no shipping
damage. Make sure all modules are seated correctly and have not detached during shipment.