User`s manual

Sierra Video Systems
7
Installation
Introduction
The Shasta 88D routing switcher consists of two pieces, the electronics frame and a
separate in-line power supply. The electronics portion of the 88D is contained on a single
plug-in circuit board which plugs into a 1RU frame.
Rack Mounting
Carefully inspect the frame to ensure that there has been no shipping damage. Make
sure all shipping material is removed from the router frame.
The Shasta 88D routing switcher can be rack mounted in a standard 19" (RU) EIA rack
assembly and includes rack "ears" at the ends of the front of the frames. None of the
switcher models require spacing above or below the unit for ventilation.
If ample space exists, a 1RU spacing gap is recommended.
To rack mount the routing switcher, simply place the unit's rack ears against the rack rails
of the rack, and insert proper rack screws through each of the holes in the rack ears.
Always rack mount the routing switcher prior to plugging the unit into a power receptacle
or attaching any cables.
Dimensions
The dimensions of the Shasta 1616D (905016) are;
Height- 1RU (1.75”)
Depth- 8.5”
Width- 19”
Chapter
2