Installation guide

Installation And Software Manual
p.5
• PowerDsine #PD-3001/AC
• 10/100Base-TX
• Single Midspan POE port
• MSRP $49 (www.provantage.com
)
Camera Location and Environment
Outdoor installation requires an appropriate enclosure to protect the camera.
Operating ambient temperature is 0ºC to 50ºC.
Camera Mounting
Cameras are mounted using a ¼” x 20 threaded hole at the bottom of the housing. When mounting the camera make
sure the screw that goes into the hole is short, ¼” or less, and does not touch the camera board.
The camera is to be installed according to the applicable code. The mounting means should be adequate for mounting
a 1 lb camera plus the weight of the lens.
Camera Power Supply
AV2100 and AV3100 cameras should be powered from 9V to 12V DC power source providing at least 4W per camera.
AV3130 requires 5W. 12V – 1A is recommended. Alternatively, the cameras can be powered over Ethernet with 48V.
A UL-approved isolated supply is required for use in the US. In the European Community the power supply must meet
the requirements of the Low Voltage Directive and be CE marked.
Camera Optics
A wide variety of C/CS mount ½” lenses may be used with AV cameras. Note that some CS lenses and all C-mount
lenses may require an adaptor ring. Our lens suggestions include:
• Xavee L-04510MVF (4.5-10 mm), L-1040MVF-IR (10-40 mm)
• Tamron 12FM04T (4mm), 12FM06T (6mm), 12FM12T (12mm)
• Fujinon DF6HA-1B (6mm), HF9HA-1B (9mm), HF12.5SA-1 (12.5mm), CF12.5HA-1(12.5mm)
• Computar M0814-MP (8mm), M1214-MP (12mm), H3Z451CS (varifocal 4.5-12mm)
Auto-Iris Lenses
Standard DC auto-iris lenses can be used with AV2100 and AV3100 cameras equipped with the auto-iris feature.
Arecont Vision recommends high-resolution optics. Our suggestions for auto-iris lenses are:
• Xavee L-04510AVF (4.5-10 mm), L-1040AVF-IR (10-40 mm)
• Computar HG3Z4512FCS (varifocal 4.5-12mm)
• Tamron 12FG04T-SQ (4 mm), 12FG06T-SQ (6 mm) and 12FG12T-SQ(12mm)