Owner`s manual

19 18
Connecting Smart Device to your Remington 2020
(Required to use Remington 2020 and ShotView Apps)
1. After the optic is turned on, press the Power button again to turn Wi-Fi On. Wi-Fi icon will appear in the
HUD when Wi-Fi is active.
2. Go to your smart device Wi-Fi settings and select the Remington 2020 system you wish to connect to.
Network name will appear as “REM_ ####” (where #### represents the last four numbers in
the rifle’s serial number)
3. Enter password. “REM-####” (where #### represents the last four numbers in the rifle’s serial
number)
Devices supported
You will need either an Apple iOS or Android device to use Remington 2020 and TrackingPoint Apps.
Apple iOS
1. Access the App Store on your mobile device or through iTunes.
2. Search the App Store for the desired application - Remington 2020, Remington 2020 Hunter, or ShotView.
3. Follow the installation procedure from device or web site.
Android
1. Access the Google Play Store.
2. Search Android Apps for the desired Application - Remington 2020, Remington 2020 Hunter, or ShotView.
3. Follow the installation procedure from device or web site.
Downloading Apps to New Devices
Wi-Fi Range
Wi-Fi range between a smart device running ShotView and the Remington 2020 is approximately 35 feet.
Troubleshooting Connection
Problem:
• Remington 2020 App - App will not launch without a network connection to a Remington 2020.
• ShotView - Video does not stream when App is launched.
Check:
1. Check if Wi-Fi icon appears in the HUD. If not, press the power button to turn scope Wi-Fi on.
2. Check if a Remington 2020 system is selected in your device’s Wi-Fi network settings.
3. Follow on screen instructions when displayed on an App.
Troubleshooting Video Streaming
• Streaming may get interrupted if too many devices are simultaneously running ShotView while connected
to one Remington 2020. Limit to 3 devices.
• If ShotView loses connection with scope and does not automatically reconnect, check to make sure your
device hasn’t reverted to a previously connected network. You may need to re-select your optic’s network
in your device settings.
Digital Optic System Errors
Below is a brief explanation of errors and level of severity that may occur while using your Remington 2020.
If any of these errors occur, you will be instructed with a message in the HUD as to the procedure to resolve.
Consumer Service
Remington Consumer Service can be reached at 1-800-243-9700 Monday-Friday between the hours of
9:00 AM and 5:00 PM Eastern.
Warranty
For information and warranty registration go to www.shoot2020.com/warranty
connecting Apps to 2020
Cleaning Lenses
Clean lenses carefully using a lens brush first to remove dust followed by a cotton swab with distilled water,
pure alcohol, or a high quality glass cleaner.
Level 1
Minor system faults where it is still possible to operate the Remington
2020. A ‘check’ icon will be visible in the HUD to indicate the error condi-
tion.
Level 2
Major system errors that impair the ability of the Remington 2020 digital
optic system to operate in Advanced Mode. A ‘check’ icon and mes-
sage will display in the HUD to indicate the error condition. The scope is
limited to operating only in the Traditional mode.
Call Consumer Service.
Level 3
Serious faults that indicate the Remington 2020 is not operational in
any mode. These errors will be displayed in the HUD during start-up and
cannot be cleared by the user. All functions are disabled.
Call Consumer Service.