User manual

Smart Interface User Manual

IM-SIP-B 3

Table of Contents

Sierra’s Smart Interface Software........................................5

Using This Manual...................................................5

Note and Safety Information........................................6

Technical Assistance.................................................6

Overview of Smart Flow Meters.........................................7

System Requirements and Software Installation.......................8

Getting Started .............................................................9

Using the Smart Interface Software Basic Features.................11

Write User Full Scale Value ......................................12

Write K-factor Value...............................................12

Write Zero Flow Cutoff Value....................................13

Write High Alarm Set Point Value...............................13

Write Low Alarm Set Point Value................................14

Write Alarm Deadband Value.....................................14

Select Speed of Response.........................................15

Select Re-Read Smart Electronics................................15

Using the Smart Interface Software Advanced Features............16

Voltage Zero and Span Adjust....................................17

Current Zero and Span Adjust....................................17

Save Variables to Disk.............................................18

Read Variables from Disk.........................................18

Using the Validation Screens...........................................19

Read Curve .........................................................20

Run System Validation............................................21

List of Figures

1. Flow Meter RS-232 Connections..................................9

2. Smart Interface Software Main Screen ..........................10

3. Advanced Options Screen.........................................16

4. Validation Screen...................................................19

5. Read Calibration Curve............................................20