User manual

Smart Interface User Manual
18 IM-SIP-B
Save Variables to Disk
To save the configuration of the currently attached flow meter:
1. Select Advanced Options from the main screen. Choose the
Function Selector and select Save Variables to Disk.
2. Select the desired filename and location. Click OK to continue.
The system reads the original factory calibration data from the
Smart flow meter electronics and stores the information on disk.
3. Click Return to return to the main screen.
Read Variables From Disk
Make sure you have a copy of the existing configuration file before
replacing it with a new file. To upload a saved configuration file to
the currently attached flow meter:
1. Select Advanced Options from the main screen. Choose the
Function Selector and select Read Variables From Disk.
2. Click OK to continue. Enter the password 93940 and click OK
to continue.
3. Select the desired file to upload. The file data is first displayed
on the screen to allow any additional changes. If the settings are
correct, select Write Above Variables into the Smart Electronics
Now.
4. The software uploads the new configuration information to the
attached Smart flow meter electronics.
5. Click Return to return to the Advanced Options screen. The new
settings are immediately in effect.
Caution!
Do not change the
flow meter’s factory full
scale setting.