Installation Instructions

7/ 16
2. Overview
2.1Introduction
Thank you for choosing SMC. It is our commitment to provide our valued
customers with the embedded devices equipped with the state‐of‐the‐art
technologyandthebestproductservices.
SMC’s M2M products are based on the most advanced ARM and Intel Atom
processors and have low‐power consumption and high integration. The products
are designed for applications of M2M in industrials, medicals, financial, retail,
vehicle,andtransportationsetc.

2.2Howtosetupandusethedevice
To use the device, please install the unit stably, and assemble its antenna(s) for
WLAN(Blue‐Tooth), CELL, if the device is configured for CELL function, maybe you need to
activatethe SIM cardagainstpropercarrier,andthenpleaseinsert correct12‐24V DC cableto
the power jack of the device, the dev
ice will be powered up and the PWR LED lighting
indicatesthe system bootsup.The device has a standard RJ45 Ethernet port which supporting
10M/100MFull/HalfDuplex.

2.3Specification
Specifications
CPU
Processor
TI, AM3352, ARM Cortex-A8,32-Bit, 600MHz
Low Power Processor
Memory
On Board RAM
DDR3 400MHz, 256MB
Flash
512MB
Wireless
Communication
WLAN/BT
SDIO WLAN/Bluetooth  Module, 802.11 b/g/n, 2.4GHz, internal
Antenna
LTE Module
1x PCIe Slot for LTE Broad Band Module with Micro SIM slot
(USB Interface Indeed) Option for UART Interface
Peripheral
Interfaces
Ethernet
1x100M
SD card
1x Micro SD card
COM Port
1xRS232/RS485, (isolated)