Instruction manual

LS300G GSM/GPRS/EDGE/HSPA+ Sierra Wireless Cellular Modem
Click on WAN/Cellular for the following screen:
Enter the APN as shown in the screen above. The example is for an APN =
I2GOLD.
After the template file has been loaded, and the APN entered, click Apply to
save the changes in the modem
.
Click Reboot to restart the modem. Alternately, reset the modem by pressing
Reset on the front of the modem or by removing power from the modem.
Click Logout to terminate communications with the modem.
Unless you Apply the commands, the changes made
will not be saved in the modem. For most commands,
you must reboot the modem for the newly written values
to take effect.
The modem is now set up in serial server mode. To enable PPP mode, see
Section 7.6, Enabling PPP Mode
(p. 19).
7.6 Enabling PPP Mode
The first step in enabling PPP mode is using the template file to configure the
LS300G as described in Section 7.5, AceManager and Template Files
(p. 16).
After configuring the modem, you must use DevConfig to configure the
datalogger for PPP mode.
Connect to your datalogger in DevConfig and go to the PPP tab.
WARNING
19