Instruction manual

LS300G GSM/GPRS/EDGE/HSPA+ Sierra Wireless Cellular Modem

5. For PakBus® dataloggers, set the PakBus Address to match that of the

datalogger (default address in the datalogger is 1). Click Apply to save

the changes.

4.5 Set Up Hardware

The simplest hardware setup for modern dataloggers is to connect a null

modem cable (CSI pn 18663) between the RS-232 ports of the datalogger and

the LS300G. See Section 7.3, Wiring and Connections

(p. 13).

4.6 Test the Connection

After the Network Map has been configured, test the cellular connection using

the Connect screen as shown below. Click on the appropriate station and click

Connect to initiate a call to the datalogger. If the call is successful, the

connectors at the bottom of the screen will come together and clock

information from the datalogger will be displayed in the Station Date/Time

field. If the connection fails, a Communications Failure message will be

displayed. Troubleshooting procedures can be found in Section 9,

Troubleshooting

(p. 22).