Instruction manual

LS300G GSM/GPRS/EDGE/HSPA+ Sierra Wireless Cellular Modem

3. Replace the SIM card cover.

FIGURE 4-1. SIM card installation

4.3 Configure LS300G

Quickstart describes configuring the LS300G in serial server

mode. It may also be configured in Point-to-Point Protocol (PPP)

mode. For a description of the modes, see Section

5, Overview (p.

. For instructions on setting up the LS300G in PPP mode, see

Section 7.5, AceManager and Template Files

(p. 16), and Section

7.6, Enabling PPP Mode

(p. 19).

The LS300G setup for serial server mode may be done with the Device

Configuration Utility (DevConfig) version 2.09 or later. DevConfig may be

updated/downloaded at no charge at www.campbellsci.com/downloads. (The

LS300G can also be set up in serial server mode using template files. See

Section 7.5, AceManager and Template Files

(p. 16).)

Connect a serial cable (for example, USB-to-serial, CSI pn 17394) between the

PC and the 9-pin serial port on the LS300G.

Open DevConfig (either from the PC’s Start menu or by clicking the icon

within LoggerNet) and select LS300 from the Cellular Modem group in the

left panel.

NOTE