Installation guide

AirCard 800 Series Installation Guide
Note: Users of Windows 2000
must be logged in with adminis-
trative privileges. Users of
Windows XP may require admin-
istrative privileges.
Note: The installer runs twice—
once to install Watcher and once
to install the Network Adapter
Manager.
Note: Do not forcefully insert the
AirCard. This may damage
connector pins. If you have more
than one PC Card slot, you may
obtain better signal strength
using the top slot.
Installation on Windows 98,
2000, Me, and XP
Note: If you are running Windows 98 SE, Me, or 2000, Windows
Installer Redistributable 2.0 must be installed. This is available on the
Microsoft website, www.microsoft.com.
Note: You may require your Windows CD. Ensure you have the CD
before proceeding.
1. If the AirCard CD is not already in your CD-ROM drive,
insert it. The CD should autostart and display a menu.
· If the CD does not autostart, select Start > Run and enter
d:\setup.exe where d is the drive letter of your CD-ROM
drive.
2. From the CD start-up menu, select your language, then
notebook installation, and then notebook software installation to
launch the installer.
3. Use the Next and Back buttons to navigate through the
installer.
4. If the SIM is not already inserted in your AirCard, insert it.
(See page 9.) If the antenna is not yet attached, attach it.
(See page 11.) With the label facing up, insert the AirCard
into your PC Card slot.
14 2130623