Installation guide

Configuring Your Account
5. Select the Advanced folder if you want to set 3G Watcher to
launch your Internet browser, VPN, or any other program
automatically, or if your service provider specified an IP
address or DNS address(es). Otherwise, click
OK and skip
to Step 10.
6. Select the Launch after connecting field, and from the
drop-down list, select which application, if any, you want
3G Watcher to automatically launch when a connection is
established with this profile:
·
None—No application is autolaunched.
·
Browser—3G Watcher autolaunches your default
Internet browser.
·
MS VPN—3G Watcher autolaunches a VPN connection.
· Application—3G Watcher autolaunches an installed VPN
program, or any other program.
7. Complete the appropriate field, depending on the option
you chose in the Launch after connecting field:
· If you selected
Browser —in the URL field, type the URL
for the web site you want to view on connection (such as
www.sierrawireless.com).
· If you selected
Microsoft VPN—in the Microsoft VPN
(PPTP) connection field, select the VPN connection from
the drop-down list.
· If you selected
Application —in the Application field, enter
the path to the program or use the browse button to
locate the .exe file for the software application you want
to autolaunch.
8. If your service provider has given you an IP address, in the
Advanced folder, select TCP/IP. Select Static IP and enter the
address in the field below. Otherwise, select
Dynamic IP.
(This is the default because most networks use dynamic IP
addressing.) Use the data compression or IP header
compression fields if supported by your service provider.
Note: Do not select the Use IP header compression field unless your
service provider is using this compression. The AirCard modem
cannot maintain a connection if this is enabled but not supported on
the network.
9. If you have a DNS address or addresses, click DNS Settings
and enter the address(es). (In most cases, it is not necessary
to enter a DNS address.)
10. If you have more than one profile, select
Profiles, and in the
Default Profile field choose the default profile from the
drop-down list. (The “default” profile is the one used by
the Autoconnect feature, and is also used if you click
Connect without selecting a profile.)
Rev 1.3 Sep.07 31