Installation guide

AirCard 800 Series Installation Guide
Note: Skip this section if your
AirCard modem comes with an
installation CD.
Caution: To avoid the risk of
explosion, use the same battery
model as the one that originally
came with your AirCard USB
modem. Dispose of a used
battery according to the instruc-
tions on it.
1. Insert the SIM card into your AirCard modem as shown on
page 19.
2. Insert the AirCard modem into the computer.
3. The installation process starts automatically.
If it does not, select
Start > Run and type d:\setup.exe (where
d is your TRU-Install CD-ROM drive letter).
4. Follow the onscreen instructions.
The AirCard modem is ready to use once the software is
successfully installed.
On subsequent insertions of the AirCard modem, TRU-Install
verifies that the correct software is already installed. If it is,
then the modem is ready to use. This process takes a few
seconds.
If you have any problems with the TRU-Install process, please
refer to the Sierra Wireless website at:
www.sierrawireless.com/TRU-Install.
Reinstalling the software
If you need to reinstall or repair the 3G Watcher software, use
the Software Installation Mode.
1. Open the
Control Panel.
2. Double-click
TRU-Install.
3. Follow the onscreen instructions.
AirCard USB modems
1. Inserting the battery
1. Slide the front panel off the AirCard USB modem.
2. Hold the battery so that the side with two white arrows
faces up and the gold contact points on the end of the
battery line up with the gold contact points on the modem.
Insert the battery into the AirCard USB modem.
3. If you have not inserted your SIM card, proceed to the next
section, ”2. Inserting the SIM card”. Otherwise, gently
slide the front panel onto the AirCard USB modem until it
clicks in place.
For additional battery information, see page 40.
22 2130893