Operation Manual

3
INSTRUCTIONS FOR USE
The Eco-Steamer is designed to thoroughly clean floor surfaces, bath room,
toilet, kitchen, windows, sofa...etc.
Warning: On surfaces that have been treated with wax, the wax may be
removed by the heat and steam action. Do not direct steam onto a cold
window.
HOW TO ASSEMBLE AND USE
Filling the boiler tank before use.
Warning: Before unscrewing the Filler Cap, always ensure that the Eco-Steamer is off
and disconnected from the power supply.
Unscrew Safety Filler Cap and using Funnel, pour into the tank two measures cup of
water. Screw Safety Filler Cap back on again.
Turning on the Eco-Steamer.
Warning: Before connecting the appliance to the power supply, ensure that the
voltage shown on the rating label matches the local supply voltage. Always connect the
Eco-Steamer to an earthed socket.
To turn on the Eco-Steamer, insert the power cord plug into an earthed socket and
press ON/OFF switch. Switch is lighted when it is turned on.
Warning: To prevent steam from being accidentally released, shift Safety Slider to lock
position.
Wait for about 4 minutes and press the Steam Trigger to supply steam.
Eco-Steamer
Eco-
Steamer
When first using the and every time it is left unused for a while, always
lift the Gun upward until the Hose is extended to its full height to prevent condensation
of water inside the Hose, and point the Gun to a sink and discharge by pressing the
Steam Trigger any water that has been formed in the Hose. As soon as the
starts supplying steam, it is ready for use.
Accessories:
1.Extension spout:
It can be attached to the Gun or Extension Tube when extra length is required.
2.Round brush:
Two pieces of round brush are provided, it is to attach to the extension spout.
3.Floor brush:
It is used with extension tubes and provided with Floor Cloth Pad.
4.Fabric Brush and Glass Squeegee:
Fabric Brush can be attached to the Gun. Attach the Fabric Brush Pad to the brush
when needed. The Glass Squeegee can be fitted to the Fabric Brush by inserting
squeegee side hooks into brush tabs and pressing two parts together.