Basic Documentation

93 / 130
Siemens M-bus level converter and M-bus web server A6V11157985_en--_f
Smart Infrastructure 2021-06-21
The following information and settings are available.
 LOG: Displays whether the error message was registered in the event log.
 Email: Displays whether an email was sent due to the error message.
 Event name: The event name is predefined. It can, however, be changed as
needed.
 Event type: Displays the event type received from the device.
 Status: Displays whether the alarm is active or not active.
Click "…" to open a new pane with the following settings:
 Actions:
– Add to log: Select whether this alarm is added to the event log.
– Send email: Select whether notification is sent by email when this alarm
occurs.
 Input conditions:
You can select the bit from the M-bus status byte for the device that represents
the corresponding alarm notification.
Click Save to apply the alarm settings. You must confirm to apply the settings!
Settings identified by (**) can transfer the settings to all devices of one type by
selecting the check box if multiple devices of the same type are installed on the
plant.
In this panel, you have access to the device list (controllers) and can change
settings.
The list is empty if no device search has been run. The devices that are found and
saved are displayed on the list after a device search.
Note
Controller settings
Note