Environmental Declaration

EPD - Type II
Based on ISO 14021
Building Parts
CuZnPb Armature variant
Steel stainless Transducer cup + Cover 6g
Steel stainless reflector 6g
Steel >5% alloyed magnetic shield 4g
Steel stainless screws, plates 7g
Steel >5% alloyed screws, plates 3g
Steel <=5% alloyed Seal + Wire 2g
CuZnPb sensor adapter 14g
Cu / Al / Polyester fleece / Silicone Cable / Wire 38g
Cu / TPE-U temperature sensor DS 38 mm 1.5 m 90g
Piezoceramic (PZT) transducer 1g
Lithium-Thionylchloride Batteries variant
22-PAP paper Operating Instructions. SBT 18-lang. 86g
22-PAP paper Installation Instructions, SBT 18-lang. 176g
FR4; halogenated; solder SnAgCu main PCB 44g
FR4; halogenated; solder SnAgCu M-Bus 12g
Passive components 157pcs
Active components 8pcs
ICs 6pcs
Weights in brackets are already included in components declared under materials. (part of the assembled PCB)
*Variant parts list
[g]
Total weight of device
Armature
Batteries
Fire load [MJ]
Comments
A5W00208322A-AA-001 01.12.2021
Metals
Others
The device is classified as waste electronic equipment in terms of the European Directive 2012/19/EU (WEEE) and must
not be disposed of as unsorted municipal waste. Regarding disposal, use the systems setup for collecting electronic waste.
Observe all local and applicable laws.
Disposal
PCBAs (Printed Circuit Board
assembled)
Regulation (EC) No. 1907/2006 (REACH)
The device is low-halogen with exception of:
Cableparts (ETFE isolation); damping body of transducers (FKM); PCB (TBBA)
Special components
(part of the assembled PCB)
Please contact your local Siemens branch office to get further information on environmental aspects and disposal.
Legal Disclaimer: This declaration is for information purpose only.
Landis+Gyr GmbH therefore does not assume liability for any error or for any consequences which may arise from the use of this information to the maximum extent under the
law.
This Environmental Product Declaration does not constitute a guarantee of the composition of a product, neither does it guarantee that the product will retain a particular
composition for a particular period.
EU-directive 2011/65/EU (RoHS)
The device does not contain substances in concentrations and applications banned under the EU RoHS Directive, including the 4 phthalates added to Annex
II in 2015.
The device contains the following substances of the candidate list according to Article 59 (1, 10) of the regulation (EC) No. 1907/2006 concerning the
Registration, Evaluation, Authorisation and Restriction of Chemicals (REACH) in concentrations above 0.1 % w/w. Contained REACH candidate substances,
including those which will become known at a later date, are listed on the delivery note.
Lead titanium zirconium oxide, CAS-Nr.12626-81-2; Lead, CAS-Nr.7439-92-1
(Status according to the creation date of this document.)
34
1111
S55561-F286
1’754
34
10
17
980
10
940
17
980
S55561-F284
1’737
S55561-F287
1’714
940
S55561-F285
1’697
Page 2/2