User Manual

S17 Meter type: Heat meters or
combined heat/cooling meters
S18 Meter type: Cooling meter
S21 Current flow rate
S22 Error message
S23 Power supply: Mains
S24-S26 Power supply: Battery with capacity
indicator
S27 Module identifier
S28 Current loop display (LOOP)
S29-S32 Tariff display
13-15 Current display code (LCD-ID)
3.3 Display current meter reading
The meter displays the current meter reading in kWh, MWh,
MJ or GJ.
Note
To avoid reading errors, the decimal places of
displayed values are marked by a frame.
Note
The calibrated value is indicated by an additionally
displayed star symbol (S12).
Note
Depending on the device parameterisation, both the
display scope and the displayed data may deviate
from this description.
3.3.1 Display values
The meter displays are arranged in multiple loops (LOOPs).
The default state is LOOP 0.
Proceed as follows to switch between the LOOPs:
• Press button 2 until the desired LOOP appears.
After the last loop LOOP LE, LOOP 0 is displayed again.
3.3.2 Advancing in a loop
To advance to the next display value within a loop, proceed
as follows:
• Press button 1.
After the last display value, the first display value appears
again.
3.3.3 Loop "LOOP 0"
The meter is in loop "LOOP 0".
• Press button 1 to advance to the next display value.
The LCD displays the following values one after the
other:
Table 2: Loop "LOOP 0"
Loop head
Error message
(here: currently no
error)
Current energy
quantity (here:
kWh; heat meter;
installation
location: Return
flow; tariff on)
Current volume
Current value tariff
register 1 (only if
tariff was
selected)
Current value tariff
register 2 (only if
tariff was
selected)
Current value tariff
register 3 (only if
tariff was
selected)
Segment test
Firmware version
CRC/CMAC
Siemens Smart Infrastructure A6V11906002 14.01.2020 10