Installation Instructions

Document No. 563-002
Installation Inst ructions
January 12, 2007
WLAN0005R1
Liquid Tight Fitting
Installed in
Enclosure Knockout
Liquid Tight Fitting
Threaded Body
Antenna
Base
Antenna
Liquid Tight Fitting Locknut
Antenna Cable 12 inches
(305 millimeters)
Liquid Tight
Fitting Nut
Figure 5. Remote Mount Antenna.
7. Position the antenna in a vertical orient
ation (up
or down).
CAUTION:
For factory installations: The antenna
must be protected during shipment to avoid
damage.
The installation is com p lete.
FCC NOTES:
This device complies with Part 1
5 of the FCC Rules.
Operation is s ubject to the fol
lowing two conditions:
1. This device may not cause harmful interference.
2. This de v ice must accept any in
terferen ce
received, including interf
erence that may cause
undesired operation.
Changes or modifications not expressly approved by
the p arty respo nsible for c ompliance could void the
user’s authority to operate the equipment.
To comply with FCC’s RF ex
posure limits for general
population/uncontrol
led exposure, the antenna(s)
used for this transmitt
er must be installed to provide
a separation distance of at least 20 cm from all
persons and must not be co-located or op era ting in
conjunction with any other antenna or transmitter.
FCC Interference Statement (Part 15.105 (b))
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuan t
to Part 1 5 of the FCC Rules . These lim its are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions , m ay cause h armful
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the u ser is encourag ed to try
to correct the interference by one of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Industrie Canada Certification:
This device has been designed to operate with
an antenna having a maximum gain of 5dBi. An
antenna h a v in g a highe r gain is strictly prohibited
per regulations of Industry Canada. The required
antenna impedance is 50Ω.
To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power
(EIRP) is not more than that required for successful
communication.
The W ireless Fie ld Level Network Transceiver
(FLNX) is to be installed or replaced by professional
installation personnel only.
Information in this document is based on specifications believed correct at the time of publication. The right is reserved to make changes as
design improvements are introduced. Product or company names mentioned herein may be the trademarks of their re spective ow ners.
© 2007 Siemens Bu ilding Technologies, Inc.
Siemens Building Technologies, Inc. Your feedback is important to us. If you have Document No. 563-002
1000 Deerfield Parkway comments about this document, please send Country of Origin: US
Buffalo Grove, IL 60089-4513 them to [e-mail].
Page 4 of 4
U.S.A.