User's Manual

Industry Automation and Drive Technologies - SCE
TIA Training Document Page 43 of 65
Module E11
Status: 01/2010 Radio Frequency Identification (RFID) with SIMATIC S7-300F-2PN/DP and
RF180C
Notes
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
Time value:00-3F
Time factor
Variable
Description
Setting the MOBY Operating
Operating Mod
e
Value
IM Type
Default
-; reserved for setting with switch
or GSD parameterization:
different interfaces without switch
under- stand under MOBY mode
= 0 the MOBY I_mode.
MOBY I or MOBY E (without MDS
507)
All
MOBY
F
with MDS F4xx
MOBY U/D or RF30
0
–
without multi tag handling
Res
.
for MOBY U
–
with multi tag handling
Reserved for MOBY D or RF300 - with multi tag
handling
(FB55)
MOBY I with MDS 507
MOBY F with MDS F1xx
MOBY F
(reserved for MDS
To be noted:
MOBY_mode must on
ly be changed after an IM is switched on
Scannung_time is the scanning time for the MDS 507 of MOBY I and MOBY V. For all other
MDS types, the value 00 can be used.here. The figure below shows the setting for the
scanning time (refer also to configguratio
n manual for Reader 44/MDS 507):
Example: The result of a scanning time of 1 second = 81 hex for the parameter ABTA
(
scanning time
)