Technical data

① Hard disk
② Hard disk screws
Fig.8-3: Position of the hard disk and of the fastening screws (inside)
7. Remove the connecting cables of the hard disk.
8. Remove the fastening screws of the hard disk. After mounting, the four
fastening screws for the hard disks are located either on the rear side of
the device door or on the fastening screw holders.
9. Exchange the old hard disk for a new hard disk.
10. The new hard disk is to be fixed according to the mounting location using
screws.
Observe the different screw lengths for the outer and inner fastening
screws of the hard disk.
11. Reconnect the connecting cables to the hard disk. Connection pins must
not be bent!
12. Close the device door and fasten the five marked screws, see fig. 8-2
"Loosen the fastening screws at the mounting frame" on page 49.
13. The new hard disk parameters are automatically identified by the system.
If the operating system does not boot automatically, the power supply is
to be interrupted for at least 10 seconds. A restart is to be carried out again.
14. After a regular booting of the PC, the user data as well as the operating
system settings for the normal operating mode are to be restored.
50/101 Bosch Rexroth AG | Electric Drives
and Controls
Rexroth IndraControl VSB 40.3 | Project Planning Manual
Maintenance and Installation