Instruction manual

10
en
Fold out picture pages.
Setting up
Version A
 Engage the handle in the telescopic
tube.
To remove the handle, press the notch
button and pull the handle out of the
telescopic tube.
 Turn the locking ring on the vacuum
cleaner to position and insert the
telescopic tube in the opening.
 Lock the telescopic tube in place by
turning the ring to position .
To remove the telescopic tube, move
the ring back to position and pull
out the telescopic tube.
 Connect the floor tool to the vacuum
cleaner.
Version B
 Turn the locking ring on the vacuum
cleaner to position and insert the
handle in the opening.
Lock the handle in place by turning
the ring to position .
To remove the handle, move the ring
back to position and pull out the
handle.
 Fit the telescopic tube to the vacuum
cleaner.
 Connect the floor tool to the
telescopic tube.
ELECTROMATIC
®
brush
Your vacuum cleaner is equipped with
an ELECTROMATIC
®
brush. For notes on
use and maintenance, please refer to the
accompanying instruction manual.
Figure
Press the adjusting sleeve in the
direction of the arrow and adjust the
telescopic tube to the length required.
Figure
Release the lower power cord hook
by turning it and remove the cord
from the upper power cord hook.
Connect the plug to the mains socket.
Figure
Turn the vacuum cleaner on/off at the
switch.
Figure
Adjust the suction setting by turning
the rotary control.
Vacuuming
Figure
Adjusting the floor tool:
 Rugs and
carpets =>
 Hard surfaces =>
Vacuum using flexible tube
Figure
a) Switch off the vacuum cleaner.
b) Press the rotary knob in the direction
of the arrow to release it and set it to
the flexible tube position.
c) Pull the hose adapter out of the
holder in the direction of the arrow.
6
5
4
3
2
1
Innenteil 206 764 A 18.08.2006 14:13 Uhr Seite 10