Data Sheet for Product
GAMMA instabus
Technical product information
February 2012
DELTA isystem wall switch, single
wall switch, double
wall switch, triple
Siemens AG UP 22x/2, UP 22x/3 and UP 22x/5, 8 pages Technical manual
Infrastructure & Cities Sector, Building Technologies
Control Products and Systems Siemens AG 2012 Update: http://www.siemens.com/gamma
P.O. Box 10 09 53, D93009 Regensburg Subject to change without further notice
2.16.1.11/7
Figure 3: Mounting sequence
F1 Bus coupling unit (BTM) UP 117
F2 Bus Transceiver Interface (BTI) on Bus coupling unit
(BTM)
F3 Design frame (DELTA line, vita, miro)
F4 Bus Transceiver Interface (BTI) on wall switch mod
ule
F5 Basic push button module
F6 Transparent frame with buttons
F7 Mounting screws
F8 Back cover (white) for labeling insert
F9 Learning button for switching between normal op
erating mode and addressing mode for receiving
the physical address
F10 LED for indicating normal operating mode (LED off)
and addressing mode (LED on); upon receiving the
physical address the device automatically returns to
normal operating mode
F11 switch buttons
F12 notch
F13 Orientation light (LED)
F14 Barcode label with KNX serial number
Labeling
− To insert a label remove the transparent frame with the
switch buttons (F6) from the main module (F5). Sepa
rate the white label holder (F8) from the transparent
frame (F6). Label a transparent plastic labeling medium
(e.g. Avery Zweckform No. J4720 for inkjet printers or
Avery Zweckform No. L4770 for laser printers) that you
insert into the transparent frame (F6) with the white
label holder (F8). Slide the transparent frame back onto
the main module (F5).
Address assignment
− Remove the transparent frame with the switch buttons
(F6) from the base module (F5) by inserting a screw
driver laterally into the recesses and lifting the trans
parent frame upwards from the base module.
− Press the learning button (F9) on the device to initiate
the assignment of the physical address to the device.
− The programming LED (F10) turns on to indicate the
programming mode. Upon receiving the physical ad
dress the device automatically returns to normal oper
ating mode and the LED turns off.