Product manual

Installing Advanced Server for UNIX Installing server software (asxserver package)

Product Manual U7613-J-Z815-6-76

If the server is not started, the following message gives you information on how to upgrade

later:

Access Control Entries can be upgraded from the LAN Manager 2.x accounts

file (/var/opt/lanman/datafiles/accounts.lm2) after the user accounts and

groups have been replicated to this backup controller.

You will need to manually run lmxupgrade -A ... after this has occurred.

In this case, the administration files must be adjusted after Advanced Server for UNIX has

been started.

Ê Start AS/X with asx start.

Ê Use the net user command to check whether the account data has already been trans-

ferred to this backup domain controller. If it has not been transferred, you can start the

transfer using the command net accounts /sync. If there are problems transferring the

account data, you may have to call /var/opt/lanman/bin/joindomain to re-establish the

connection again.

Ê If the account data has been updated on this backup domain controller, the access

permissions must be created for Advanced Server for UNIX. Call

/var/opt/lanman/bin/lmxupgrade -YA.

Watch the output of the command for files and directories which are not found for

upgrading access permissions.

4.8.4 Upgrade installation of a primary domain controller from

Version 3.5 or 4.0

To upgrade a primary domain controller from a previous Advanced Server for UNIX version,

proceed as follows. In contrast to an upgrade installation from Version 2.x, the data can be

upgraded directly; no conversion has to be done.

Ê Log on as system administrator root.

Ê Start the installation procedure as described in the section “Installing from CD-ROM with

cdinst”.

Ê Select the asxserver package under AS/X.

Stop the server

Ê Choose y to stop the server.