User's Manual

TC12 Installation, Commissioning & Maintenance Handbook
2.2.
lowing, additional, cards installed in it.
ink t needed if processor card has built-in
2.2.
uld normally have
the following, additional, cards installed in it.
• Digi I/O Card
ver Card (IMD) Xem.
2.2.2
the PC; a
The setting up of a 3Com Etherlink 3 card is described below. There are no links
or j rs on a configuration program.
Wit Ether ed up and at the C: DOS
prompt The TC12 software installation disk should be inserted into the PC’s floppy
driv the f p program:
A:\ELNK3\3C5X9CFG.EXE
P abled
I/O Base Address 0H
Int Lev
Transceiver type Auto Select
o : If Plug and Play is enabled, this should be disabled first, the configuration
sav nd PC ot efo ny r s gs h
2.2.2
8
lled in the PC. To run the program the TC12 software installation disk should
A:\UM9008\DIAG9008.EXE
e
ration. The arrow
2.4.2 Rack Mount Wall Map PC
A rack mount PC which is to be used for driving the LEDs on a wall map would
normally have the fol
• Ethernet Card (E 3) (notherl
Ethernet)
• Digi I/O Card (1 per digital output rack)
2.4.3 Flat Panel Data Transmission PC
A flat panel PC which is to be used for data transmission wo
• Intelligent Modem Dri
.5 3Com Etherlink 3 Ethernet Card Set Up
The Ethernet card (part number 667/7/22609/014) needs a half slot in
ll slot can be used if there are no half slots available. fu
umpe the card and the set up is performed using
h the net card installed in the PC, the PC boot
e and ollowing command used to run the set u
The set up part of the program to set the parameters listed below to the values
shown:
lug and Play Dis
30
errupt Request el 3
Network Driver Optimisation DOS Client
N te
ed a the rebo ed b re a othe ettin are c anged.
.6 UM9008 On-Board Ethernet Set Up
Where the processor card has a built-in Ethernet controller (UM9008) the UM900
configuration and diagnostic utility program should be run before any boards are
stain
be inserted into the PC’s floppy drive and the following command used to run the
diagnostic utility program:
The first screen of the DIAG9008 program shows the current configuration with the
options of Accept and Exit, Diagnostics, or Configuration. To change th
configuration, select Configuration, followed by Modify Configu
666/HE/43100/000 Page 14 Issue 9