User's Manual

TC12 Installation, Commissioning & Maintenance Handbook
3.3.3.62 Display Mains State Inputs (KDI)
nable U mains state inputs to be displayed in
eaks so that the value displayed
t r the n or off (because the voltage
n the mains cycle, if the input was
th r time oss over point, the display may indicate that
e particular mains supply was off, erroneously).
3.3.3.6
K
troller lamp supplies as
3.3.3.64 Display L U Le
ispla ects of all
nfigu its 0 to 3, for the
atus o 3 are displayed, bits
3.3.3
cod
unts to be displayed.
CT 0 = 65535
C e
s
10
KDI (input port number: 0 - 3) <enter>
Comment: E s the state of the LM
binary format.
The state of the input is only sampled at mains p
indicates whe he particular mains supply is o
sensor output fluctuates depending on the point i
sampled at o e s e.g. the zero cr
th
3 Display Lamps ON/OFF State (KLM)
mp supply: 0 - 1) <enter> LM (la
Comment: Indicates the state for each of the con
shown below:
6 - lamps off
7 - lamps on
8 - change in progress (debounce period)
M arn Status (KLS)
KLS <enter>
aspComment: D ys the combined learn status bits for all
o , bc red sensors. Refer to KAS command
st bit definitions and layout. Only bits 0 t
4 to 7 are always 0.
.65 Display Comms Message Log (GCT)
GCT (comms log e: 0 - 6)
Comment: Enables comms message and error co
Note: To clear the comms log enter the command G
Comms Log od Item
0 good message
1 CRC errors
2 framing errors
3 sync errors
4 sync timing errors
5 sync byte corrupt errors
6 4 second time out errors
7 Upload / Download framing errors
8 Upload / Download block CRC errors
9 Upload / Download good blocks
Upload / Download good messages
666/HE/43100/000 Page 112 Issue 9