User's Manual

TC12 Installation, Commissioning & Maintenance Handbook
For sensors monitoring a phase or wait indicator, the value entered defines the
, 2=phase C etc.
se together, the value
e A
a
0 = pha
ry signs the value = 255.
3.3.3.34 Controller dim/bright changes expected (KDP)
assumes that the controller will perform
3.3.3.35 Maximum
KDL = (0 to 25
Comment: Maximum number of dim/bright changes in a 24 hour period that
are allowed before a dim change fault is indicated.
ring.
3.3.3.36 Flashing t (KFD) L
KFD (0 - 1) = ( - 255
Comment: ome ntrollers have a long term flashing mode that
nnot red by the LMU. During the flashing period the
LMU can be disabled by allocating an input to inform the LMU that
the signals are flashing. There are two possible input types that can
be used:
KFD 0 = (input number: 0 - 31) (255 to disable).
This allocates a suitably configured controller output to the OTU
input that goes active when the signals enter flashing mode.
phase identity, i.e. 0=phase A, 1=phase B
For sensors monitoring a vehicle and a pedestrian pha
entered defines the vehicle phase identity and the pedestrian phase is by default
allocated the next phase identity, e.g. a value of 0 allocates the vehicle to phas
and by default the pedestrian is allocated phase B.
For sensors monitoring switched signs, the value entered defines the drive phase
nd colour:
se A, red drive
1 = phase B, red drive
etc
16 = phase A, amber drive
17 = phase B, amber drive
etc
32 = phase A, green drive
33 = phase B, green drive
etc.
For sensors which are unused or monitoring regulato
KDP = { 0 or 1 } (1)
Comment: The default configuration
dim/bright changeovers. If there is no change in a 24 hour period a
dim change fault is indicated. For controllers with no dimming
facility set KDP = 0 to disable this monitoring function.
allowable dim/bright changes (KDL)
5) (63)
Note: Setting KDP = 0 does not affect this monito
Signals LMU disable inpu
0 )
S export co
ca be monito
666/HE/43100/000 Page 104 Issue 9