User's Manual

TC12 Installation, Commissioning & Maintenance Handbook
3.3.3.28 Display Fault Data (GLD)
ith certain fault flags
ffset from starting index
ses
- failures in low 4 bits
2 - Rise/fail counts - aspect pattern 1
il c pect p
- Rise/fail counts - aspect pattern 3
- Rise/fail counts - aspect pattern 4
- Rise/fail c pect p
- Rise/fail c spect p
The data in the log is generally indicated against aspect pattern number as
follows:
Aspect Pattern No
GLD (Fault data index : 0 - 227)
Comment: To examine fault data associated w
Fault data index 0 - 215 Lamp Fault Data (Fault flags 0 - 3 Lamp Faults)
If the KLP command is supported this information is also available using KLP.
The data for each current sensor is as follows:
O
0 - Phase identification 0 = A, 1 = B etc
1 - Number of current rises / Lamp failures - aspect pattern 0. Ri
in high 4 bits
3 - Rise/fa ounts - as attern 2
4
5
6 ounts - as attern 5
7 ounts - a attern 6
Lamp Colour
0 Red (R R
1 Green (G), Green Man (Gm), Wait (Wt) or Sign (S)
2 Amber
- port lamp sequence wing pa ers are used
1 Flashing Amber Ball (FL.B) (for XV2 type)
3 Flashing Amber (FL.A) (for XV3 type)
The following monitor types can record a fault in more than one aspect pattern
number for failure of one colour. The aspect number where the failure is actually
logged will depend on which aspects were showing at the time of the failure.
M nitor
) or Red Man ( m)
(A)
for Ex s the follo ttern numb :
o type Failed Colour Pattern No.
- UK Pelican and Intersection Ped. Including wait if Wt off
t on
Wt
Gm
K Pelican and Intersection Ped. Stream R 3
G
Wt 5 if A on
6 if G on
Gm 3
Rm 0
2 if W
2
1
U
A 1
2
Rm 1 if A on
2 if G on
666/HE/43100/000 Page 99 Issue 9