User's Manual

Automation and Drives - SCE

T I A Training Document Page 47 of 64 Module

14. In the hardware configuration, at Properties of the CPU, a fixed cycle time can be set for

executing OB35.

However, this cycle time should not be selected too short. It has to be ensured that all blocks

called from OB35 can be processed within this time, and if OB1 is used at the same time, that

there is enough time for it also. (→ Execution)

Enter execution

time

15. Open ‘OB35’ from SIMATIC Manager (→ OB35)

Double click on block

'OB35'

Preface Fundamentals Discontinuous Action Controllerr Controller Block (S)FB41 Setting the System Appendix

Issued: 02/2008 Control Engineering with STEP 7