User's Manual
Automation and Drives - SCE
T I A Training Document Page 45 of 64 Module
10. Note down the addresses of the IO modules (addresses are assigned automatically and
tied to the slot).
For our example, change the addresses to the values PEW 128 and PAW 128.
Save the configuration table and load it to the PLC (key switch on CPU has to be on Stop!)
Preface Fundamentals Discontinuous Action Controllerr Controller Block (S)FB41 Setting the System Appendix
Click on symbol ‘Save and
convert’
Click on symbol ‘Load to
AS’
Double click on line "AI5/A02,
then re-write start addresses to
PEW/PAW 128
11. Highlight Blocks in SIMATIC Manager
Click on 'Blocks'
B3
Issued: 02/2008 Control Engineering with STEP 7