Specifications
AT Command Set
TC3X_ATC_01_V04.00 Page 8 of 204 29.05.2002
6.2 144ff AT^MONI Examples on page 144 updated.
<chann> and <rs> explained in greater detail
References for 3GPP TS 05.05 and 05.08 added
Frequency hopping will now be indicated with “h”
(instead of the previously used “0”.
Notes modified: If during a connection the radio cell is
changed, the parameters PWR and RXLev of the
‘Serving Cell’ part will not be updated.
Statement regarding RING line revised.
Statement regarding different values of identical cell
monitoring parameters (used for AT^MONI,
AT^MONP and AT^SMONC) added.
6.3 146 At^MONP <chann> and <rs> explained in greater detail
Notes modified: During a connection new neighbour
cells can be added, but their parameters C1 and C2
will be updated after the call.
Statement regarding RING line revised.
6.7 152 AT^SCKS Notes regarding empty SIM card tray corrected.
6.13 157 AT^SLCK New <class> parameters added.
6.17 161 AT^SMONC New AT command: Cell monitoring
6.25 166 AT^SNFPT New AT command: Switch on / off Call Progress tones
6.20, 6.22,
6.24 – 6.28
163ff AT^SNF… All Chapters revised.
6.37 177 AT^SSCONF New AT command: Configuring recipient address
parameters in SMS result codes and in +CDS URCs.
6.38 178 AT^SSDA New AT command: Set display availability
7.1.2 183f CMS errors List of codes revised: Deleted unnecessary codes.
Note and example added: Mapping of CME and CMS
errors if SIM PIN authentication has not been done.
7.1.4 187 Result codes “Connect 14400/RLP” added.
7.1.5 187 Location ID for
AT+CEER
List of codes revised: Deleted unnecessary codes.
7.1.11 191 Release cause
for call control
Notification 300 and note regarding Location ID
added.
7.4
7.4.1
198
200
*# codes Abbreviations explained in greater detail.
Further examples added.
7.3 196 AT+VTS Added to List of PIN1 independent AT commands
"AT Command Set" Version TC3x-ATC-01-V03.00=> TC3x5-ATC-01-03.10
Chapter Page AT command
What is new
1.4.2 12 Any command
AT+IPR
Maximum length of command line buffer added.
To be used standalone.
2.13 25 ATI[value] Only value 9 supported
2.37 35 AT&S <value>2 removed
2.20 27 ATS0 Notes added
2.26 30 ATS7 Notes added
2.46 41 AT+IPR Recommendation added: To be used standalone.
2.46.1 42 AT+IPR List of bit rates detectable in autobaud mode
3 43 Fax commands Note added: Autobauding recommended when using
standard PC Fax programs