Specifications

AT Command Set
TC3X_ATC_01_V04.00 Page 28 of 204 29.05.2002
2.21 ATS2 Escape code sequence
Read command
ATS2?
Response
S2 determines the decimal value of the ASCII character used in the escape code
sequence, which serves, during a data call, to change from data to command
mode. Compare Chapter 2.2.
The default value 043 is equivalent to an ASCII “+”. Please note that the value
cannot be changed, and therefore, test or write commands are not supported.
Reference
V.25ter
Note
2.22 ATS3 Write command line termination character
Read command
ATS3?
Response
<n> OK
Write command
ATS3=<n>
This parameter setting determines the character recognized by TA to terminate
an incoming command line.
Response
OK
Parameter
<n> 000-013-127 command line termination character
Reference
V.25ter
Note
2.23 ATS4 Set response formatting character
Read command
ATS4?
Response
<n> OK
Write command
ATS4=<n>
This parameter setting determines the character generated by the TA for result
code and information text.
Response
OK
Parameter
<n> 000-010-127 response formatting character.
Reference
V.25ter
Note