Specifications

AT Command Set
TC3X_ATC_01_V04.00 Page 106 of 204 29.05.2002
Example 3
To change the "PS" lock password, using the correct old password:
AT+CPWD=PS,1111,2222 (where 1111 = old "PS" password and 2222 =
new password)
To specify a new "PS" lock password, after the old password was disabled, e.g.
after three failed attempts to enter the password (only if Master Phone Code is
availbale):
AT+CPWD=PS,12345678,1111 (where 12345678 is the Master Phone code
and 1111 is the new password. You may also
use <newpwd> to restore the former disabled
password). This operation deactivates the
present phone lock and sets a new one. See
also Chapter 4.31.1.
Alternatively, whithout giving a new password:
AT+CPWD=PS,12345678 Deactivates the present phone lock.
4.35 AT+CR Service reporting control
Test command
AT+CR=?
Response
+CR: (list of supported <mode>s) OK
Parameter
See write command
Read command
AT+CR?
Response
+CR: <mode> OK
Parameter
See write command
Write command
AT+CR=<mode>
Response
Configures the TA whether or not to transmit an intermediate result code +CR:
<serv> to TE when a call is being set up.
OK
Parameter
<mode> 0 disable
1 enable
Intermediate result code
If enabled, an intermediate result code is transmitted at the point during
connect negotiation when the TA has determined the speed and quality of
service to be used, before any error control or data compression reports are
transmitted, and before any final result code (e.g. CONNECT) appears.
+CR:<serv>
Parameter
<serv> REL ASYNC asynchronous non-transparent
Reference
GSM 07.07
Note
The PLMN influences the second air interface (to the terminator), therefore
another mode may be established from the network